Finally started working on my light desk, was going to cut the hole for the disk today but the damn disk wasn’t delivered today :C Here’s a pic of what I have so far though with an artistic representation of the bits I still need to make.




Made it with an old table stand and a few bits of wood. I plan to make the height adjustable by using two long metal screws (its one long metal screw at the moment but I can soon make it 2..) I will have to make a wide hole to fit it in so it has room to move about to allow the angle of the metal pole to change when the height is adjusted. I also plan on attaching some old snooker table cloth around the back to stop the light from bleeding into the rest of the room. As for those lights, I don’t know if Its good to have a shelf attached to the top board or to leave them like in the pic, one light its bright enough to light a room pretty well.

Still a shame about the disk though.. I cant really work on any of it until I get the hole cut for the disk and with out the disk I cant really accurately measure where to put the cut.


alsoalso I made some further progress on that acting clip I'm making. That can be seen here [link]